Wacker Neuson EZ38, Operator'S Manual

Page: 26 / 254

2-14
OM EZ38 us – 1.1* * Sicherheit(us).fm
• Batteries contain caustic sulphuric acid. When handling the battery,
observe the specific safety instructions and regulations relative to
accident prevention.
• A volatile oxyhydrogen mixture forms in batteries during normal
operation and especially when charging. Always wear gloves and eye
protection when working with batteries.
• Starting the machine with a battery jumper cable can be hazardous if
performed improperly. Observe the safety instructions regarding the
battery.
• Before taking up work on machine parts hazardous for life and limb
(bruising, cutting), always ensure safe blocking/support of these areas
• Perform maintenance and repair work beneath a raised machine,
attachments or additional equipment only if a safe and secure support
has been provided for (the sole use of hydraulic cylinders, jacks etc.
does not sufficiently secure raised machines or equipment/attach-
ments)
• Avoid contact with hot parts, such as the engine block or the exhaust
system during the operation of the machine and for some time after-
wards – burn hazard!
• Retainer pins can fly out or splinter when struck with force – risk of
personal injury!
• Do not use starting fuel! This especially applies to those cases in which
a heater plug (intake-air preheating) is used at the same time – risk of
explosions!
• Apply special care when working on the fuel system – increased risk of
fire!
Tracks
• Repair work on the tracks must be performed only by trained technical
staff or by a Wacker Neuson service center.
• Malfunctioning tracks reduce the machine's operational safety.
Therefore, check the tracks regularly for cracks, cuts or other damage.
• Check track tension at regular intervals.
Electric energy
• Use only original fuses with the specified current rating.
• In case of electrical system malfunctions, switch off the machine
immediately, disconnect the battery (by using the battery master
switch), and perform troubleshooting procedures.
• During operating the machine, maintain a safe distance from overhead
electric lines! If work must be performed close to overhead lines, the
equipment and attachments must be kept well away from them.
• If the machine comes into contact with a live wire:
• Immediately travel the machine out of the danger zone.
• Warn others against approaching and touching the machine.
• Do not leave the machine until the line that has been touched or
damaged has been safely de-energized!
• Make sure that work on the electric system is performed only by a
technician with appropriate training, in accordance with applicable
electrical engineering codes.
• Inspect and check the electrical equipment of the machine at regular
intervals. Defects such as loose connections or scorched cables must
be repaired immediately.