Wacker Neuson EZ38, Operator'S Manual

Page: 25 / 254

OM EZ38 us – 1.1* * Sicherheit(us).fm
2-13
• Disconnect the negative battery terminal when working on the
electrical system.
• Do not allow the machine to be serviced, repaired, or test-driven by
unauthorized personnel.
• If maintenance with the engine running cannot be avoided, lower the
stabilizer blade and raise the control lever base.
• Wear a safety harness when performing elevated maintenance on or
with the machine. Keep all handles, steps, handrails, platforms,
landings, and ladders free from dirt, snow and ice.
• Always use specially designed or otherwise safety-oriented ladders
and working platforms to perform overhead assembly work. NEVER
use machine parts or attachments/superstructures as a climbing aid!
• Do not use the work equipment as lifting platforms for persons.
• In accordance with this Operator’s Manual and instructions for the
respective assembly, release the pressure in all system sections and
pressure lines (hydraulic system) before performing any maintenance
on or with the machine.
• Prior to performing assembly work on the machine, make sure no
movable parts will roll away or start moving.
• To avoid the risk of accidents, parts and large assemblies being moved
for replacement purposes must be carefully attached and secured to
lifting gear.
• Use only suitable lifting gear and suspension systems in a technically
perfect state with adequate load-bearing capacity! Stay clear of
suspended loads!
• Clean the machine, especially connections and threaded unions, of
any traces of oil, fuel or preservatives before performed maintenance/
repair work!
• Do not use aggressive detergents!
• Use lint-free cleaning rags!
• Before cleaning the machine with water, steam jet (high-pressure
cleaner) or detergents, cover or tape up all openings which – for safety
and functional reasons – must be protected against water, steam or
detergent penetration. Special care must be taken with the electrical
system.
• After cleaning, remove all covers and tapes applied for that purpose!
• After cleaning, examine all fuel, lubricant and hydraulic oil lines for
leaks, chafe marks and damage!
• Rectify all defects without delay!
• Always tighten any screw connections that have been loosened during
maintenance and repair!
• Any safety devices removed for set-up, maintenance or repair
purposes must be refitted and checked immediately upon completion
of the maintenance and repair work
• Make sure all consumables and replaced parts are disposed of safely
and with minimum environmental impact!
Special Hazards
Battery
• In case of a frozen battery or of an insufficient electrolyte level, do not
try starting the machine with battery jumper cables. The battery can
burst or explode.