Wachs SDB 206, User Manual, Page: 30 / 76

SDB 206 and FF 313
28 Part No. 56-MAN-01, Rev. B E.H. Wachs
Tooling Set-Up
caUtion
Disconnect the air supply whenever changing or adjusting the form tools.
Install the facing tool in the Rotating head. Refer to Tool Charts for the appropriate tool bit. All tool
bits must be installed so the cutting edge will contact the pipe when rotating in a clockwise
direction, as seen from rear of machine. The tool bits are locked into place with the set screws
adjacent to the slot (Figure 3-3). DO NOT allow tool to come in contact with mandrel or damage
may result.
Figure 3-3.