Wachs FF 424, User Manual, Page: 9 / 70

Chapter 2, Safety: Operator Safety
E.H. Wachs Part No. 66-MAN-01, Rev. A 7
Protective Equipment Requirements
For additional information on eye and face protection, refer
to Federal OSHA regulations, 29 Code of Federal Regula-
tions, Section 1910.133., Eye and Face Protection and
American National Standards Institute, ANSI Z87.1, Occu-
pational and Educational Eye and Face Protection. Z87.1 is
available from the American National Standards Institute,
Inc., 1430 Broadway, New York, NY 10018.
Hearing protectors are required in high noise areas, 85 dBA
or greater. The operation of other tools and equipment in the
area, reflective surfaces, process noises, and resonant struc-
tures can increase the noise level in the area. For additional
information on hearing protection, refer to Federal OSHA
regulations, 29 Code of Federal Regulations, Section
1910.95, Occupational Noise Exposure and ANSI S12.6
Hearing Protectors.
1. THIS MACHINE HAS BEEN DESIGNED WITH
VIBRATIONAL CONCERNS IN MIND.
2. IF EXCESSIVE VIBRATIONS OCCUR, RATE
MAY BE TOO FAST AND/OR NOT ENOUGH. THIS
CAN USUALLY BE CORRECTED BY TAKING
A DEEPER CUT.
3. CHECK THE POWER SUPPLY HOOKUP FOR ANY
LOOSE CONNECTIONS.
4. MAKE SURE THE CUTTING TOOL IS SEATED
PROPERLY AND TIGHTENED AS WELL.
5. BE SURE THAT THE WORKPIECE IS WITHIN
THE MACHINES OPERATIONAL CAPACITY
Always wear impact resistant eye pro-
tection while operating or working near
this equipment.
WARNING
CAUTION
Personal hearing protection is recom-
mended when operating or working near
this tool.