
SDB 412/2 SMALL DIAMETER BEVELER
BEVELING MACHINE TO FLANGE FACER CONVERSION PROCEDURE
4. Mount flange facing tool slide on macrune
rotating head. Align dowel pin holes in flange
facer with the dowel pins on the machine head.
(FIG. 3)
NOTE: Be sure to install the felt washer. Coat the
washer with a light amount of oil in the rear
of the flange facing module.
1. Remove the mandrel from the machine body.
Next, loosen and remove the four 3/8-16 x 1-1/4”
shcs securing the rotating tool holder plate
(Fig. 1).
2. Remove the rotating tool holder plate, (part # 66-
005-00) from the machine body by lifting it from
the two dowel pins pressed into the rotating
head. (Fig. 2)
Fig. 1
Fig. 2
3. Install the trip collar assembly onto the machine
housing by tightening the six locking socket set
screws located on the out diameter of the collar
assembly (Fig. 2).
NOTE: When installing the trip ring assembly, center
the cut out relief on trip ring over the air motor
housing for proper trip lever location. Be sure
that ring sits flush against housing all around.
Fig. 3
5. Secure with four 3/8-16 x 1-1/4” shcs.
Fig. 4
15
Summary of Contents for FF 424
