51
Operational faults
Possible cause
Remedy
Axis skid can only be moved
with considerable force
Clamping lever of the axis is
tightened
Open the clamping lever
Guide play is set too narrowly
Adapt the guide play
Play of the trapezoidal-threa-
ded nut is set too narrowly
Adapt the play of the trapezoi-
dal-threaded nut
Sleeve stroke too short
Borer stroke depth stop limits
the sleeve stroke
Set the borer stroke depth stop
(See „Drill stroke depth stop“)
Rust on workpieces of machi-
ne parts when using coolant
lubrication
Wrong coolant set
Check the ratio of coolant and
correct if necessary
(Do not use pure water to cool!)
Tool holder cannot be inserted
into the main spindle
Incorrect tool ball in the tool
holder
Only use the appropriate tool
holders for the machine
Use tool with take-up
Turn the tool tightening screw
back further
(See „Fitting and removing the
tools“)
Inner cone of the main spindle
or outer cone of the tool holder
is contaminated
Clean the relevant cone
Tool overheated
Revolutions too high
Reduce the revolutions
Feed too high
Reduce the feed
Working without coolant
Use coolant
Insufficient coolant feed at the
cutting edge
Align the coolant hose correctly
14. Operational faults and the elimination of such
Summary of Contents for CC-F1410 LF hs
Page 41: ...41 7 Fitting and removing the tools 42 6 Spannen und Ausdr cken der Werkzeuge 1 2 3 4 5...
Page 98: ...98 16 Drawings and legends 16 12 Spindle Z axis with ball screws 16 12 1 F1410 LF F1410 LF hs...
Page 126: ...126 16 Drawings and legends 16 22 Support arm for control panel 1 2 3 4 5 6 8 9 5 4 7 9 8...