14
1.
Important safety notes
1.6
Explanations of the symbols
With a measured noise level of 80 dB (A) at the workpla-
ce the operator should wear Ear Protection.
Caution:
Always pull the power plug prior to any maintenance
work!
Read the operating instructions prior to initial operation or
maintenance work!
Caution:
Dangerous electric voltage!
2.
Delivery and set up
The machine is packed with care at the factory.
The following should be checked after delivery:
1. Whether the packaging shows damages to be reported or
2. Whether the machine shows transportation damages to be reported If this is the case, we ask you to
communicate this information immediately. Subsequent claims cannot be recognised.
The boring and milling machine must be set up on a suitable, even and firm surface. Suitable surfaces
are, for example:
■
A machine base cabinet (available optionally)
■
A separate workbench with a level surface (spirit level) that is strong enough to carry the weight of
the machine without bending.
■
A steel plate with a level surface (spirit level)
The machine must be screwed securely to the surface it is set up on. There are holes in the base of the
machine that are designed for this purpose.
Good working results and low-vibration operation can
only be ensured when the prerequisites for fixture as set out above are maintained.
Summary of Contents for CC-F1410 LF hs
Page 41: ...41 7 Fitting and removing the tools 42 6 Spannen und Ausdr cken der Werkzeuge 1 2 3 4 5...
Page 98: ...98 16 Drawings and legends 16 12 Spindle Z axis with ball screws 16 12 1 F1410 LF F1410 LF hs...
Page 126: ...126 16 Drawings and legends 16 22 Support arm for control panel 1 2 3 4 5 6 8 9 5 4 7 9 8...