WABECO CC-F1410 LF hs, Operating Instructions Manual

Page: 37 / 159

37
4. Specifications regarding the machine
4.6 Electrical equipment (1.4 kW)
The main drive motor (single phase series-wound motor) is supplied already installed
■ The main spindle drive has an ON/OFF switch with under-voltage trigger.
■ The ON/OFF switch must also be switched on again after the power is interrupted.
■ In the event of the drive motor being overloaded, it will switch itself off automatically. The drive motor
can only be switched back on again after a short waiting period
4.7 Electrical equipment (2.0 kW)
■ The machine has a 3-setting switch (START RIGHT - STOP - START LEFT)
■ The under-voltage trigger is integrated in the electronics of the motor
■ In order to start the machine or restart after the power has been interrupted, first switch the 3-setting
switch to the „STOP“ position.
■ The switch must remain on „STOP“ for approximately 10 seconds to enable the motor to reset.
■ To change the direction of rotation of the main drive motor, the switch must rest on „STOP“ for about
1 second to allow the relays on the control board enough time to switch.
■ In the event of the main drive motor being overloaded, it will switch itself off automatically. The main
drive motor can only be switched back on again after a short waiting period.
5. Achieving optimum results
and avoiding incorrect usage
■ Use of suitable processing tools.
■ Adaptation of revolution setting and feed to the material and workpiece.
■ Clamp the tool in such a way that the clamping point is as close to the workpiece as possible.
■ Clamp the workpieces firmly and without vibrations.
■ The use of coolant and lubrication to increase the durability of the tool, improve surface quality and
accuracy.
■ Clamp processing tools and workpieces on a clean clamping surface.
■ Lubricate machine sufficiently.
■ Set the bearing clearance and guides correctly.