17
3.
Putting into operation
3.1
for all milling machines
■
Use a dry cloth to remove the corrosion protection that was applied to all exposed parts for transport
■
In the event of marine impregnation of exposed parts, it is recommended you spray them with oil,
allow it to work, and then remove the impregnation with a dry cloth.
■
Once set up properly (see the section on delivery and set up) connect the grounded plug directly to
a safety socket and the 230 V 50/60 Hz (optional 110 V 60 Hz) mains power supply.
■ Provision of sufficient coolant for the operation of a coolant unit
■
(optional)
■
Release the axis clamps and check the individual feed spindles for easy operation
■
Bei konventionelle Maschinen die Achsklemmungen lösen
■
Check all electronic control elements, for example, ON/OFF switch, emergency off switch, potenti-
ometer etc. for functionality.
3.2
for all CNC milling machines
When putting CNC machines into operation for the first time, always read the start-up manual.
3.2.1 Setting up and connecting the control computer
When selecting a suitable control computer, pay attention to the system prerequisites of the
control software. These are listed on the rear of the CD case sent with the machine.
Follow the instructions in the start manual of the software to install the control software on the computer.
The start manual can be found in the CD case of the control software included with the machine.
In the next step, the software must be adapted to your machine. To do this, follow the instructions sent
with the machine which detail the editing of the parameters.
When the software has been successfully installed on the control computer and all parameters have
been adapted successfully, the control computer must be connected with the machine controller.
The machine controller communicates with the computer via the serial interface (COM port). In order to
establish a connection between the machine controller and the computer, connect the end of the inter-
face cable that is on the machine console to the COM port of the computer.
CAUTION:
The axial cable of the step motors and the serial interface cable may only be plugged in or remo-
ved when the controller is switched off. Otherwise this may lead to damage to the controller, the
machine or the control computer.
Summary of Contents for CC-F1410 LF hs
Page 41: ...41 7 Fitting and removing the tools 42 6 Spannen und Ausdr cken der Werkzeuge 1 2 3 4 5...
Page 98: ...98 16 Drawings and legends 16 12 Spindle Z axis with ball screws 16 12 1 F1410 LF F1410 LF hs...
Page 126: ...126 16 Drawings and legends 16 22 Support arm for control panel 1 2 3 4 5 6 8 9 5 4 7 9 8...