WABECO CC-F1410 LF hs, Operating Instructions Manual

Page: 48 / 159

48
12. Maintenance
A long lifetime of the machine will depend on the appropriate care and maintenance.
■
All maintenance and repair tasks may only be carried out with the grounded plug pulled.
■ The machine must be cleaned after each use.
■ If the machine is set up in a wet room, all exposed parts must be oiled after each use to prevent
corrosion.
■ Always lubricate all moving parts well.
■ In the event of bearing or skid play, immediately adjust in order to prevent it from destroying the
bearing or skid guide.
Approximately every 100 operating hours
■ Clean the carbon brushes and collector of the drive motor (1.4 kW) with a piece of coarse sandpaper.
Remove approximately 0.1 mm from the collector, then smooth out the contact surface with fine
sandpaper.
■ Check the tension of the gear belt and adjust if necessary.
■ Check the play in the feed spindles and set if necessary.
13. Lubrication of the machine
The lubrication process
■ reduces wear and friction.
■ increases the lifetime.
■ protects metal surfaces from corrosion.
We recommend:
■ A class 2NLGI multi-purpose grease for lubrication.
■ A lubrication oil with a viscosity of 100 mm ²/s for oiling.
The machine is to be lubricated every 8 hours of operation in accordance with the lubrication plan. The
lubrication points
■ Feed spindle of X-, Y-, and Z-axes (only for trapezoidal thread spindles)
■ Sleeve and feed pinion (for sleeve stroke)
■ Bevel gear box of the Z-axis lateral drive system
are lubricated with the help of an oil can and an ordinary lubrication oil by moving the skid or sleeve
backwards and forwards.
All other lubrication points are lubricated with a grease press or a brush using multi-purpose grease.