Level
Nozzle is too far away from build plate
that causes model unable to adhere to
the build plate.
Perfect distance between nozzle and
build plate ensures filament extruded
evenly and adhering rightly on the
build plate.
0.1 mm
Note: If rotating nuts but the nozzle still cannot touch the build plate, it might due to the position of the Z-axis limit
sensor being too high; please adjust it accordingly.
18
1. Move the nozzle to the top of the leveling nut. Screw the nut and adjust the distance between the nozzle and the
printing platform to about 0.1 mm (Thickness of a piece of A4 paper).
2. We can use a piece of A4 paper to assist in leveling, so that the nozzle only scratches on the A4 paper. Adjust the
four leveling nuts in turn until you feel slight resistance from the nozzle when pulling the A4 paper.
3. Test whether the distance between the nozzle and the print platform is proper or not. Repeat the above steps 1~2
times if necessary.
Nozzle is too close to build plate that
causes filament failed to sufficiently
extruding. Nozzle may easily be
damaged and clogged, build plate
may be scratched.
It is suggested that the center
position be checked after well
adjusting the upper 4 positions.
调平
注意：如若旋转调平螺母无法使喷嘴触碰到平台，这可能是由于Z轴限位传感器位置安装过高，请适当调节。
1. 当喷嘴在调平螺母上方时，旋转螺母，调节打印平台，使二者间距约为0.1mm，刚好处于贴合状态（一张A4纸的厚度）;
2. 用一张A4纸辅助调平，使喷嘴刚好能在A4纸上产生划痕但不会划破纸张。依次完成底部四个调平螺母的调节，不断调整直到拉
动A4纸时能感受到来自喷嘴的轻微阻力;
3. 测试平台中间间隙是否合适，如有必要可重复上述步骤1-2次。
4个螺母上方位置调整后，
可适当查看中心位置是否合适。
喷嘴离平台太远，耗材无法粘附在平台上。
耗材挤出饱满均匀，刚好贴在平台上。
喷嘴离平台太近，耗材挤出不足，喷嘴容易
受损，造成堵头，刮伤打印平台。
