Wire connection
9
X、E、Z-axis motor port
X、Z-axis limit sensor
Power cable *1
！
X-axis motor
X-axis limit sensor
Z-axis limit sensor
E-axis motor
Z-axis motor
16
1
3
4
5
6
7
2
1. Connect the yellow-labeled cable with "E" on 6 pin (4 wires) port to E-axis motor.
将6针（4线）端口上带有黄色标签丝印“E”的线与E轴电机连接。
2. Connect the yellow-labeled cable with "X" on 3 pin (2 wires) port to X-axis limit sensor.
将3针（2线）端口上带有黄色标签丝印“X”的线与X轴限位传感器连接。
3. Connect the yellow-labeled cable with "X" on 6 pin (4 wires) port to X-axis motor.
将6针（4线）端口上带有黄色标签丝印“X”的线与X轴电机连接。
4. Connect the yellow-labeled cable with "Z" on 3 pin port to Z-axis limit sensor.
将3针端口上带有黄色标签丝印“Z”的线与Z轴限位传感器连接。
5. Connect the yellow-labeled cable with "Z" on 6 pin port to Z-axis motor.
将6针端口上带有黄色标签丝印“Z”的线与Z轴电机连接。
6. Pass the left power cable through the cable fixed buckle to connect with the right power cable.
将左边的电源线穿过固线扣与右边的电源线对接。
7. Plug in the power cord (as shown) and toggle the switch to turn on the power.
插入电源线(如图所示)并拨动开关以打开电源。
Attention
· Damage might occur if voltage is
set incorrectly. Make sure the
current input voltage matches to
your local mains
(115/230 V).
· Plug in power cord and turn
power switch to 1 to turn it on.
· Do not disconnect the cables
when the printer is powered on.
设备接线
X、E、Z轴电机接口
X、Z轴限位传感器接口
电源线 *1
X轴电机
X轴限位传感器
Z轴限位传感器
E轴电机
Z轴电机
注意
· 如果电压设置不正确，可能会造成
损坏。选择正确的输入电压以匹配您
的本地电源
（115/230V）
。
· 连接电源线并将电源开关拔至I档即
可开机。
· 当机器通电时，请勿断开连接线。
