29
Use
In B.P. models, when the appliance is switched on and has been running for 2 minutes, both motors will stop to allow
repositioning of the bypass valve. The motors will start up again after approximately 1 minutes.
N.B.
This is a normal system procedure and should not be perceived as a malfunction.
The appliance is wired to a special dedicated control panel, the functions of which are described further on.
This model can be used in combination with a Vortice preheater, which must be fitted and set up by the installer.
The minimum distance of the preheater from the appliance is 500 mm.
ENGLISH
Outer Display (HMI)
User interface
The user interface is used by means of a graphic display and some keys as shown in the figure below.
The following operations can be performed through the user interface:
• Operating mode selection.
• Speed adjustment.
• Temperatures control.
• Alarms management.
Key and display backlighting remains active for about two minutes after the last key is pressed. When backlighting is off,
you can switch it back on again without activating any function by pressing any key.
I
Function 1 recall key.
II
Function 2 recall key.
X
Key to exit from the displayed page.
I
Display
II
X
▲
Key to: increase speed / move to the upper
line or value.
▼
Key to: decrease speed / move to the lower
line or value.
Confirmation key (OK).
[
▲
] [
]
Summary of Contents for VORT HRI PHANTOM
Page 137: ...137 ...