VorTek SonoPro S34 Series, Instruction Manual

Page: 21 / 83

Series S34 Instruction Manual Chapter 2 Installation
M-000-00030 2-10
Figure 2-10. Small Rail/Fixture System with Worm-Clamps
Adjacent Side Transducer Installation
1. Program all the calibration menu items of the flow meter for the fluid and pipe
specifics to obtain the transducer mounting locations.
2. Position the rail/fixture system on the pipe in the desired location.
3. String the two adjustable worm-drive clamps around the pipe and the fixture as
shown in Figure 2-10. Start with a loose fit.
4. Loosen the set screw on the rightmost transducer mounting clamp and using the
scale attached to the front rail, slide the clamp so that the middle of the bracket is
close to the location determined by the flow meter. See Figure 2-11 for reference.
Slightly tighten the set screw that was loosened in the previous step so that the
clamp does not being moving when the transducer is placed inside. Note: the
leftmost mounting clamp does not need to be moved as it is already in the correct
position.
5. Connect the transducer cables to each transducer. Note that there is a key on the
male connector found on each transducer while each transducer cable has a fe-
male connector with a keyway. Align the key and the keyway on the male and fe-
male connectors to ensure a proper connection of the cable.