(Operator Protective Structure) and TOPS (Tip-
Over Protective Structure), see page
10
.
During electrical storms, do not enter or exit the
machine.
- If you are off the machine, stay well away from
the machine until the electrical storm passes.
- If you are in the cab, remain seated with the
machine stationary until the electrical storm
passes. Do not touch controls or anything
metal.
Always wear approved respirator for the materials
being used.
When travelling on, for example, very rough and
uneven ground, the operator may be thrown
about and contact with the windshield is possible.
Reduce this potential hazard by travelling at low
speed and be extra careful under these
conditions. Also wear a hard hat.
Stability when working
The stability of the machine is subjected to
considerable changes. The operator himself must
observe all special regulations applicable to every
operation in order to obtain full working safety.
NOTE!
A pre requisite for good stability is that the machine
is parked on level ground of sufficient load bearing
capacity. Care should be taken if the ground is soft
and uneven, sloped, in danger of collapsing, side
stress and other dangerous situations.
Operating on public roads
Road signs, traffic restricting arrangements and
other safety devices, which may be required
when considering traffic speed and intensity or
other local conditions, must be used.
When moving the machine with a suspended
load, special attention must be observed. When
required, request the help of a signal man.
Use lights, hazard flashers and rotating warning
beacon according to national traffic regulations.
Operating instructions
Safety rules when operating
71