sound appears two times when the settings
menu is activated.
The display shows the X1 menu settings and
during this time the selector switch for offset
boom or optional equipment (8) is only for
validation but not full flow accessory activation.
3 To change the setting for the X1: Move the
proportional roller (9) on the right control lever to
the left or right until the wanted maximum
hydraulic flow is reached. Keep the proportional
roller in this position and press the selector
switch for offset boom or optional equipment (8)
to confirm.
4 To change the setting for the X3: Move the
proportional roller (3) on the left control lever to
the left or right until the wanted maximum
hydraulic oil flow is reached. Keep the
proportional roller in this position and press the
selector switch for offset boom or optional
equipment (8) on the right control lever to
confirm.
5 The setting menu will turn off automatically after
5 seconds if no roller or switch is activated.
To validate and exit menu: Press the selector
switch for offset boom or optional equipment (7)
and then at the same time press switch for
optional equipment (8) on the right control lever.
Keep both switches depressed for 3 seconds
until exit the setting menu of accessories.
With the ESC button on the keypad you can also
leave the settings menu. By pressing the ESC
button the menu settings done previously in 3
and 4 are not saved.
6 A sound appears two times when leaving the
settings menu and the display will be back in the
mode which was selected before the hydraulic
oil flow adjustment.
NOTE!
It is possible to adjust the maximum flow for X1 and
X3 on the keypad, see page
43
.
Other controls
Controls
53