SmartCrystal™ Diamond
n ° : MUV140036
Version : A12
USER MANUAL
Date : 11/01/2018
www.volfoni.com
This document is the property of the Co VOLFONI and may not be reproduced or disclosed without permission.
61
V.
TROUBLES SHOOTING
PROBLEM
Hazy image,
poor contrast
POSSIBLE REASONS
•
The lens focus is wrong
•
The image aligning is bad
•
The protective films on the front and back sides have
not been removed
•
Presence of fingerprints or dirt on the lens and/or on
the SCD Box inflow and outflow windows
SOLUTIONS
•
Fit the lens focus
•
Check if the protective films have been removed
•
Remove the protective films and clean the inflow and outflow SCD
Box windows using the provided wipes
•
Adjust the SCD Box aligning again using the pattern
No 3-D effect
•
Problem on the silvered screen
•
Projector settings are not right
•
The SCD Box is not connected with the SCD Controller
•
The SCD Controller is not plugged in
•
The projection window depolarizes light
•
The SCD B
•
Box and the SCD Controller are not compatible
•
Check if the screen is silvered
•
Check if the ‘DarkTime’ and ‘Delay’ values are right
•
Check the SCD Controller connections. In 3-D mode, the SCD
Controller should display ‘3D ON’ and the frequency.
•
Carry out a checking by removing the room window to ensure the
latter do not influence polarization
•
Check the table compatibility table below
ELECTRONIC BOX
OPTICAL BOX
DARKTIME
VSSP ≥ 10200
VSSP ≥ 13300
350µS
VSSP 10100
VSSP ≤ 13200
1000µS
VSSP 10000
VSSP ≤ 13200
1000µS
Too dark image
•
The power of the projector lamp is too low
•
The lamp settings are badly adjusted
•
Change the lamp settings
