SmartCrystal™ Diamond
n ° : MUV140036
Version : A12
USER MANUAL
Date : 11/01/2018
www.volfoni.com
This document is the property of the Co VOLFONI and may not be reproduced or disclosed without permission.
51
Left/right fitting observing the VERTICAL lines
Align/superimpose the vertical lines at the center of the lower image using the left/right wheel located at the bottom of the
device (n°2 wheel of the image 5).
As the aligning is correct at the center, the vertical lines on the image sides are not systematically superimposed. Check
however that the gaps between
the lines are identical on the left and the right of the image (see figure below).
¶
Up/down fitting observing the HORIZONTAL lines
Fig 31
