SmartCrystal™ Diamond
n ° : MUV140036
Version : A12
USER MANUAL
Date : 11/01/2018
www.volfoni.com
This document is the property of the Co VOLFONI and may not be reproduced or disclosed without permission.
10
SmartCrystal™ Diamond Controller
b.
General presentation
The SmartCrystal™ Diamond Controller is the electronic unit of the system. Figure 6 shows a general
view of the SmartCrystal™ Diamond Controller.
Detailed presentation
1)
Automation – pluggable terminal block connector (3
points): It enables you to control the system
automatically with ‘hit or miss’ electrical entries.
2)
Network Operating Center (NOC) - RJ45 connector: It
enables you to run and to interact with the system from
a remote/relocated computer center.
3)
Sync_3D – BNC connector: Synchronization signal
generated by the projector or another source.
4)
SCD Box interface - SUBD9 connector: This interface is
used to run the SCD Box.
5)
Bracket-connector SUBD15 interfaces: This duplex interface is used to interact with the bracket and to run it to automate 2-D/3-D modes.
6)
Feeding of the SmartCrystal™ Diamond Controller.
This entry must be always used with the external feeding (5V/1.5A)
7)
Maintenance – USB connector: Entry designed for SmartCrystal™ Diamond Controller software maintenance.
8)
Digital information area about the system state and functioning.
B
The following Figure is a view of the SmartCrystal™ Diamond Controller digital display.
The screen displays:
A: The current working mode: 2-D or 3-D.
B: The vision frequency received by the system through the SYNC_3D entry.
C: Other information about the system: bracket state etc.
Fig 05
Fig 06
Fig 07
