VOGT ICE TUBE-ICE P-24A, Service Manual

Page: 97 / 146

P24A & P34A Service Manual
SERVICING OPERATIONS
12/18/12
9-11
Cutter Shaft and Bearing Installation.
1. Clean the inside of the bearing housing of grease or foreign matter. Further clean the top bearing
housing with pro-lock cleaner and primer (or a suitable substitute) and remove the pipe plugs
from the side of the housing.
2. Apply a thin coat of Loctite

RC/609 retainer (or a suitable substitute) to the inner surface and
bearing shoulder of the top of the bearing bracket.
3. Insert a bearing in the top housing and set it in place.
4. Clean the cutter shaft and press the top bearing onto the shaft.
5. Slide the upper bearing spacer on the shaft and begin driving the shaft down through the middle
bearing of the housing. Do not start the top shaft bearing in the housing.
6. Partially fill the housing with grease (MPG-2 or a USDA approved grease). Use enough to fill
the area between the two upper bearings, forcing some out the pipe plug hole when the shaft and
top bearing are seated.
7. Finish driving the shaft and bearing into the housing until it is firmly seated.
8. Turn the bracket and shaft upside down and fill the housing around the shaft with MPG-2 (or
suitable substitute) grease.
9. Slide the lower bearing spacer over the shaft and into the housing.
10. With the top end of the shaft supported, install the lower bearing on the shaft driving it down into
the housing firmly against the housing shoulder.
11. Slide the seal spacer (ridged end in, flat end out) and seal (open face out) onto the shaft together.
12. Uniformly tap the seal into the housing against its shoulder.
NOTE: The purpose of the seals and excluders are to prevent moisture from entering the housing
area not to hold the grease in.
13. Wipe off excess grease and install the two pipe plugs.
14. Install the largest excluder on the bracket as illustrated by the assembly drawing.
15. Install the tines disc, the 1/4 x 1/4 key, spacer, spring washer, castle nut, and cotter pin.
16. Turn the assembly right side up and install it in the water tank, locating the support arms as they
were match marked when removed and secure in place using the 5/8” stainless steel cap screw
and lock washer maximum torque should be 90 ft. lbs.
17. Install the top seal (open side facing out*), tapping it uniformly into the housing until it seats.
18. Install the top water excluder.
19. Install the splash shield and ice deflector plate in the ice discharge opening.
20. Install the cutter assembly, using the 1/4” X 1/4” X 3 3/16” lg. stainless steel key to align the key
ways and lock the cutter and shaft together.
21. Install the red rubber gasket, retainer, and 3/8” stainless steel socket head cap screw. Tighten to
approximately 15 ft. lbs.
22. Check and adjust the cutter height per “Cutter Height Adjustment” instructions.