VOGT ICE TUBE-ICE P-24A, Service Manual

Page: 73 / 146

P24A & P34A Service Manual
7-7
MAINTENANCE
12/17/2012
Note: It is the owner’s responsibility to make sure normal maintenance is initiated to insure that the
compressor is not subjected to premature wear or failure due to neglect or lack of sufficient
maintenance and care.
Frequency
1st 2nd 3rd 4th Thereafter
Change oil 200 hr. 500 hr. 1500 hr. 4000 hr. every 4000 hrs.
Clean suction strainer cloth 200 hr. 500 hr. Remove if clogging is minimal
TABLE 7-4
Compressor Maintenance
The above maintenance is only a guide. The compressor should be inspected anytime there is
unusual noise, damage is suspected or the oil becomes discolored. The oil should be changed any
time the compressor is opened. For specific recommendations and instructions, refer to the
particular compressor manufacturer’s manual. See “Compressor Oil Changing and Inspection”
Although the ice machine is equipped with an oil separator which has an automatic return, some oil
will pass through the separator and eventually settle in the oil trap (36), which is offset from the base
of the freezer. This oil trap will have evidence of frost on its surface during the freeze cycle and may
be more pronounced at the end of a normal freeze cycle just before the harvest. Where there is oil in
the trap, there will not be frost. Where there is frost, there will not be oil. When the trap is 1/2 to
3/4 full of oil, it should be drained.
The machine should be shutdown for at least 12 hours before attempting to drain oil from the trap.
Follow the procedure outlined in the service section, “Draining Oil Trap”.
! CAUTION !
Only qualified refrigeration service personnel familiar and
experienced in the handling and use of anhydrous ammonia (R717) should be
authorized to perform the “Draining Oil Trap” procedure.
! CAUTION !
Cutter Gear Reducer.
The oil level of the gear reducer should be checked monthly or when there is
any evidence of leakage. The correct level is indicated by the pipe plug in the side of the gear
housing. The oil should run out of the hole when the plug is taken out. If low, add oil through one
of the top plugged holes. A high grade lubricant such as Mobil 600W or SAE 140 gear oil should be
used. The oil should be changed annually. Drain the oil and flush the gear case with mineral spirits.
Drain the mineral spirits completely and refill with the proper oil.
Note: If a USDA high food grade lubricant is desired, use Chevron FM Lubricating Oil 460X.
! CAUTION !
Follow all lock-out and tag-out procedures before servicing any electrical equipment.
! CAUTION !