UD101L User Guide Document: UD101L-2
----------------------------------------------------------------------------------------------------------------------------- ---------------
35
through PC keyboard and mouse. After finish the setup, user can save the result to Box and no
more PC is required.
➢
User can backup system setting in PC and copy to other units.
➢
Firmware and MCU code update can be executed through Gwarp3. User can control multiple
units at the same time through different IP address.
8.2.1. Important concept
➢
Gwarp3 is a PC tool for convenient operation through USB or Ethernet connection.
➢
Geometry alignment in Gwarp3 is called [Warp Adjust]. OSD or Remote controller adjustment
can only execute geometry alignment up to 9x5 control points but Gwarp3 can be up to 17x17.
➢
Under 9x5 control point, the geometry result in Gwarp3 will be executed to the Box in real time.
It is the same result as OSD or remote controller operation. User can switch operation between
remote controller and Gwarp3 at any time.
➢
17x17 geometry al
ignment can’t be executed in the Box in real time. User should execute [Save
to Box] process to save the final data into Box and can find the result under [UserMap] menu.
➢
The data in [UserMap] is different format and can’t recall for further modification.
➢
The data saved in Profile Index will save all user settings including UserMap. If the UserMap
includes only up to 9x5 data, user can modify it. If it includes 17x17 data, user can’t modify it
and can only execute 2x2 corner finetune with +_50 pixels position shift in H&V directions.
➢
The data saved in Gwarp3 through [Save Setting] to PC can be as backup or copied to another
unit. It is editable and user can execute further modification.
8.2.2. Steps for geometry alignment through GWarp3 operation
➢
Set output with the same as projector native resolution.
➢
Connect GWarp3
→
Select [Pattern] type
→
[Warp Adjust]
→
[2x2]
→
[3x3]
→
[5x3]
→
[9x5]
→
[17x17].
➢
After finish geometry alignment, please select # and click [Save to Box] to save the settings into
Box. The data saved in each channel is independent.
➢
User can save the settings in PC through [Save Setting] as backup. The file name is WBF. User
can load back WBF file from PC for further editing or copy to another unit of the same model
GeoBox.
➢
When user copies PC file to another unit, please execute [Save to Box] in each channel, then
save the final result into box by [Profile save]. Otherwise, 17x17 geometry result may be lost.
8.2.3. Geometry alignment through [Warp Adjust]
➢
System Reset
✓
[CTRL + Shift + R]: Reset selected channel
✓
[CTRL + Shift + A]: Reset all channels (from CH1-CH4)
