65
4 APPliCATion - UsER inTERFACE - DoCUMEnTATion
5. the configuration program shows that all settings
have been made. one folder named "VucaM" has
been saved to the Sd card, another folder named
"VuCAM_network_config"
has been saved to your
desktop. If you have not inserted a Sd card, the con-
figuration files have been saved in a folder on your
desktop.
6. exit the configuration program by clicking on
7. remove the Sd card with the configuration files
from the Sd slot of your Pc/Laptop and insert it into
your VucaM
®
+.
8. Follow steps 1 to 4 in chapter 4.7.3.
l
4.7.3 PREPARing ThE vUCAM, page 62
9. In the following menu, you will find a file named
"Custom_Netw_fix-206.cfg"
. the file is already se-
lected. confirm your selection by pressing
Your VucaM
®
+ will now reboot. after approximately
30 seconds, the network file is successfully loaded
and you will find yourself again in the operation
menu.
10. open the setup and select "system settings". con-
firm your selection by pressing
11. Select "network configuration" using the arrow
buttons and confirm your selection by pressing
10. Make sure that the settings are set as follows:
"Streaming: active“, "Start streaming: on startup",
"Streaming type: broadcast".
11. exit the menu and go back to the operation menu
by pressing
three times.
12. Your VucaM
®
+ is now ready for streaming. In
order to start the stream, follow the steps in this
chapter:
l
4.7.5 sTART sTREAM, page 66
broadcasting places substantial de-
mands on network hardware and pay-
load management. This can lead to a
temporary network failure. Consult
your iT network specialist.
To ensure that your vUCAM
®
works
perfectly in professionally set up,
equipped and maintained networks,
viZaar has taken all precautions and
carried out extensive network tests.
Due to the multitude of network com-
ponents and network combinations,
viZaar assumes no liability of any kind
for network failures. The user is ob-
liged to set up suitable risk manage-
ment for broadcast operations and to
take appropriate measures.
