64
4 APPliCATion - UsER inTERFACE - DoCUMEnTATion
3. the configuration program shows that all settings
have been made. one folder named "VucaM" has
been saved to the Sd card, another folder named
"VuCAM_network_config"
has been saved to your
desktop. If you have not inserted a Sd card, the con-
figuration files have been saved in a folder on your
desktop.
4. exit the configuration program by clicking on
5. remove the Sd card with the configuration files
from the Sd slot of your Pc/Laptop and insert it into
your VucaM
®
+.
6. Follow steps 1 to 4 in chapter 4.7.3.
l
4.7.3 PREPARing ThE vUCAM, page 62
7. In the following menu, you will find a file named
"Custom_Netw_fix-206.cfg"
. the file is already se-
lected. confirm your selection by pressing
Your VucaM
®
+ will now reboot. after approximately
30 seconds, the network file is successfully loaded
and you will find yourself again in the operation
menu.
8. open the setup and select "system settings". con-
firm your selection by pressing
9. Select "network configuration" using the arrow but-
tons and confirm your selection by pressing
10. Make sure that the settings are set as follows:
"Streaming: active“, "Start streaming: on startup",
"Streaming type: unicast".
11. exit the menu and go back to the operation menu
by pressing
three times.
12. Your VucaM
®
+ is now ready for streaming. In
order to start the stream, follow the steps in this
chapter:
l
4.7.5 sTART sTREAM, page 66
1. Follow the steps in chapter 4.7.1: "configuring the
target device" before proceeding:
l
4.7.1 ConFigURing ThE TARgET DEviCE, page 60
2. now follow the steps 1 to 7 in chapter 4.7.4.
l
4.7.4 vUCAM
®
-lAn-PC, page 63
3. Select "VucaM-Lan-Pc" in the menu "select con-
nection type" and proceed by clicking
4. now select "stream to everybody in same Lan
(broadcast)" and confirm your selection by pressing
For more detailed information on net-
work configuration, consult your iT
network administrator!
4.7.4.2 sTREAM AUF MEhRERE gERäTE
