Vivax ACP-18CC50GEI, User Manual, Page: 311 / 345

38
●
Warning: Befone obtaining access to terminals, all supply circuits must be disconnected.
●
Electric wiring
1
、
All field supplied parts and meterials must conform to local laws and regulations.
2
、
For electric wiring,refer to WIRING DIAGRAM attached to the unit body.
3
、
All wiring must be performed by a skilled technician.
4
、
A circuit breaker capable of shutting down power supply to the entire system and which have at
least 3 mm contact seperation in each jole must be install in the fixed wiring.
5
、
Earth properly.
6
、
Wiring must conform to national laws and regulations.
7
、
The fixed wiring must be installed with a protector with no more that 30 mA leakage current.
8
、
If the supply cord is damaged, it must be replaced by the manufactory or its service agents or a
similarty qualified person in order to avoid a hazard.
●
Wiring of unit and the controller
1
、
Wiring of the indoor unit.
2
、
Remove the control box lid(1),pull the wires inside through rubber bush and wiring according to the
WIRING DIAGRAM , then tighten it with clamp.
3
、
Wiring of the controller
4
、
Remove the control box lid(2),pull wires inside through rubber bush and connect to the controller.
5
、
Wrap the wire with sealing pad(12).
6
、
After wiring,tighten it with clamp and fix the control box lid(1),(2).
7
、
Heating and cooling:connect the rubber wire (5-cords) to the power supply terminal board in
properly.
8
、
Cooling:connect the rubber wire (3-cords) to the power supply termiral board properly.