Vivax ACP-18CC50GEI, User Manual, Page: 309 / 345

36
☆
Only use median sponge to entwine the wiring interface of the gas pipe and heat preservation
sheath of the gas collection tube.
G
、
Drainage hose
1.Install the drain hose
☆
The diameter of the drain hose should be equal or bigger than the connection pipe’s. ( The
diameter of polythene pipe: Outer diameter 25mm Surface thickness
≥
1.5mm)
☆
Drain hose should be short and drooping gradient should at less 1/100 to prevent the formation of
air bubble.
☆
If drain hose cannot has enough drooping gradient, drain raising pipe should be added.
☆
To prevent bent of the drain hose, the distance between hoisting stand should is 1 to 1.5m.
×
(wrong)
○
(Correct) 1/100 or more gradient
1-1.5m
☆
Use the drain hose and clamp attached. Insert
the drain hose to the drain vent, and then tighten
the clamp.
☆
Entwine the big sponge on the clamp of drain
hose to insulate heat.
☆
Heat insulation should be done to indoor drain
hose.
●
Drain step up pipe note
☆
The install height of the drain raising pipe should less than 280mm.
☆
The drain raising pipe should form a right angle with the unit, and distance to unit should not
beyond 300mm.
Below 4mm
Sponge(attachment)
Clamp(attachment)
Clamp
Drain hose Sponge (gray)