ENVI Series: VTC-IR40-N
27
9.4.
Using DHCP Server
If your network has a DHCP server running for assigning IP addresses, you may choose to let it
assign IP addresses to the IP devices on the list. To do that, first open the Network Setup window
either by Manual IP Setup or Automatic IP Setup procedure. Choose DHCP in “IP Type”
selection, then IP Address, Netmask, Default Gateway field in Network setup area on the
window will be disabled to input as shown below.
Note: If your network has more than one IP address Zone at the same time, the
confirmation window will be displayed as below. You need to choose the one you
are going to use for your IP devices.
Summary of Contents for VTC-IR40-N
Page 8: ...ENVI Series VTC IR40 N 7 3 VTC IR40 N Layout 3 1 Front View 3 2 Rear Side View...
Page 57: ...ENVI Series VTC IR40 N 56 Exposure AGC Automatic Gain Control You can adjust the AGC manually...
Page 146: ...ENVI Series VTC IR40 N 145 Enhanced Draw Mode On Off Enhance image for a better reproduction...