ENVI Series: VTC-IR40-N
8
4.
VTC-IR40-NInstallation
• Make sure the power is not applied before the installation.
4.1.
Mounting The Camera
1.
Drill 4 holes into the wall or ceiling using the supplied template
2.
Insert the anchors into the drilled holes
3.
Match (foot mount holes) to the drilled holes
4.
Affix the mounting bracket by using supplied screws
4.2.
Connections
1. Power
Depending on the type of installations, apply power to the camera by one of the three
options below.
a) Via Ethernet – Use only with POE switch (100 Meters max distance)
b) 12VDC - Use with 12VDC 1A ** SEE IMPORTANT NOTES BELOW **
c) 24VAC- Use with 24VAC for longer distances.
**
It is required that the polarity-matched connection is made for 12VDC supply,
otherw ise IR LEDs w ill not operate at night. **
Primary and secondary grounds are completely isolated to avoid possible ground-loop
problems.
Summary of Contents for VTC-IR40-N
Page 8: ...ENVI Series VTC IR40 N 7 3 VTC IR40 N Layout 3 1 Front View 3 2 Rear Side View...
Page 57: ...ENVI Series VTC IR40 N 56 Exposure AGC Automatic Gain Control You can adjust the AGC manually...
Page 146: ...ENVI Series VTC IR40 N 145 Enhanced Draw Mode On Off Enhance image for a better reproduction...