ENVI Series: VTC-IR40-N
55
14.3.1.
Rate Control Mode
14.3.2.
Image Quality Setup
In Image Quality level setup, select “Low Compression” for higher image quality, but it requires
higher network bandwidth. Selecting the “Lowest” requires lower network bandwidth, but gives
decreased image quality.
After configuration is finished, click Apply button to save the setting. If you click Default button,
the entire configuration will be reset to the original values.
Motion Detection
•
Motion Detection:(this is only available in Primary Stream) If enabled, Motion Detection
feature is activated and user can configure the areas where motion detection function will work.
Click Check All button for whole scene to be active (grid will turn Green) then click on any box
inside scene to take out that area from Motion Detection (box will turn Red) then clickApply to
save
•
Motion Sensitivity: Set the sensitivity of motion defined in Motion Detection Area. Select
between -100 and 100. 100 is the most sensitive.
After all the settingsare done, click Apply button to save it. If Default button is clicked, all the
fields return back to original value.
14.4.
Camera Control (Select Models)
Select Camera Control on the bottom of Camera & Motion Configuration menu.
Summary of Contents for VTC-IR40-N
Page 8: ...ENVI Series VTC IR40 N 7 3 VTC IR40 N Layout 3 1 Front View 3 2 Rear Side View...
Page 57: ...ENVI Series VTC IR40 N 56 Exposure AGC Automatic Gain Control You can adjust the AGC manually...
Page 146: ...ENVI Series VTC IR40 N 145 Enhanced Draw Mode On Off Enhance image for a better reproduction...
