ENVI Series: VTC-IR302FN
54
14.3.1.
Rate Control Mode
14.3.2.
Image Quality Setup
In
Image Quality
level setup, select “Low Compression” for higher image quality, but it requires
higher network bandwidth. Selecting the “Lowest” requires lower network bandwidth, but gives
decreased image quality.
After configuration is finished, click
Apply
button to save the setting. If you click
Default
button,
the entire configuration will be reset to the original values.
Motion Detection
Motion Detection
: (this is only available in Primary Stream) If enabled, Motion Detection
feature is activated and user can configure the areas where motion detection function will work.
Click
Check All
button for whole scene to be active (grid will turn Green) then click on any box
inside scene to take out that area from Motion Detection (box will turn Red) then click
Apply
to
save
Motion Sensitivity
: Set the sensitivity of motion defined in Motion Detection Area. Select
between -100 and 100. 100 is the most sensitive.
After all the settings are done, click
Apply
button to save it. If
Default
button is clicked, all the
fields return back to original value.
14.4.
Camera Control (Select Models)
Select
Camera Control
on the bottom of
Camera & Motion Configuration
menu.