PowerDome Installation Manual
Housing Installation
4)
Using a 5 mm drill bit, drill all five fastener holes. Ensure that all holes are drilled perpendicular to
the panel.
5)
Cut a hole in the panel using the penciled tracing as a guide.
To attach the kit to the panel and install the panel, perform the following.
1)
Place the long side of the T-bar support brackets flush against the inside of the panel. Align the
mounting holes with the drilled holes in the panel.
2)
Place the ceiling ring on the T-bar brackets with its smooth side down and its mounting holes
aligned with the mounting holes on the brackets.
3)
Using the ceiling ring mounting holes, secure the ceiling ring in place with two of the flathead screws
provided. Tighten the screws enough to draw them flush with the panel surface.
4)
Replace the ceiling panel with the attached T-bar support kit in its original location.
5)
Attach the T-bar support to the panel braces using the holes provided.
1040647A / July 2003
11
Summary of Contents for PowerDome Series
Page 1: ...PowerDome Series Installation Manual...
Page 44: ......
