EN - 19
viscount
User Manual
2.
Use the [BANK] button to enable or disable the Stand-By mode according to the rule:
-
Only the [A] LED is on: Stand-By enabled
-
Both [A] and [B] LEDS are on: Stand-By disabled
3.
Press the [REC] button to return to normal operation.
6.8 OPERATING SYSTEM UPDATE
Whenever a
Cantorum IV Plus
operating system update file is released, it will be made available on the
website www.viscountinstruments.com.
After downloading the file, copy it to the root folder of a USB stick and insert the pen into the connector
[ ] on the back panel when the instrument is off.
Hold down the [TRANSPOSER] and [MAN.I 4'] buttons to turn on the instrument with the
[TEMPERAMENT] button (therefore startup from Stand-By mode): if the USB stick and update file are
recognized and validated the LEDs of the [TRANSPOSER] and [MAN.I 4'] buttons flash alternately to
indicate that the update has started, after which the LEDs stop flashing.
If the USB stick or update file is not recognized or validated, the LEDs of the above buttons do not start
flashing and the panel remains completely off. In this case, turn the instrument off using the [POWER
ON] switch, then try another update. If this should also fail to download the file again and/or use another
USB stick, then redo the update.
6.9 DISPLAYING THE OPERATING SYSTEM VERSION
To be informed about the version of the operating system currently installed on the instrument, follow this
procedure:
1.
Holding down the [SET] button press the [REC] button: all LEDs on the panel flash twice.
2.
Press and hold the button [1]: the LEDs of the registers display the installed version number,
indicated as X.Y according to the rule:
-
The registers of the Bass and Manual I sections indicate the number X, from left to right
starting from "1", the last register indicates the number "0". If, for example, the LED of
the second register is on, this means that X is “2”.
-
The registers of the Manual II section indicate the Y number, from left to right, with the
same rule described for the number X.
3.
Release the [1] button and press the [REC] button to turn it back to normal operation.
