EN - 18
viscount
User Manual
6.5 ORCHESTRAL VOICES AND ORGAN STYLES IN COMBINATIONS
Normally, combinations store the on-off status of registers (also orchestral), tremolo, Split and sub-super
octave setting.
Cantorum VI Plus
also allows to memorize the type of orchestral voice for each register
(that is, for example, the same button in a combination plays the piano and in another the trumpet) and
which organ style must be recalled.
To enable these memorizations, follow this procedure:
1.
Holding down the [SET] button press the [REC] button: all LEDs on the panel flash twice.
2A.
Use the [MEMORY] button to
enable or disable the memorization of orchestral voices
,
according to the rule:
-
Only the [INT] LED is on: memorizing is disabled (only the register status is stored)
-
Both [INT] and [USB] LEDs are on: memorizing of orchestral voices is enabled
2B.
Use the [STYLE] button to
enable or disable styles memorization
, according to the rule:
-
Only the [INT] LED is on: memorizing is disabled
-
Both [INT] and [USB] LEDs are on: memorizing is en<abled
3.
Press the [REC] button to return to normal operation.
6.6 CALIBRATING THE EXPRESSION PEDAL
Connecting to the [EXPR.] connector an expression pedal, it may be useful to calibrate it if the pedal
operating range is not complete.
To calibrate the pedal, follow this procedure:
1.
Holding down the [SET] button press the [REC] button: all LEDs on the panel flash twice.
2.
Set the pedal to the minimum position (fully raised pedal).
3.
Press and hold the [VOICE 1] button in the MAN. I ORCHESTRA section until the
corresponding LED is switched off.
4.
Set the pedal to the maximum position (fully lowered pedal)
5.
Press and hold the [VOICE 2] button in the MAN. I ORCHESTRA section until the
corresponding LED is switched off.
6.
Press the [REC] button to return to normal operation.
6.7 ACTIVATION/DEACTIVATION OF STAND-BY MODE
As described in chapter 2,
Cantorum VI Plus
is equipped with a Stand-By mode through which the
instrument automatically switches to low power mode after 30 minutes of inactivity.
It is however possible to disable this automatic Stand-by mode with this procedure:
1.
Holding down the [SET] button press the [REC] button: all LEDs on the panel flash twice.
N.B.
-
When saving to the internal memory or USB stick, keep in mind that files with the same name
are irreparably overwritten. However, you can create personal folders with other names in the
USB stick, as well as rename your . mem files. When loading into
Cantorum VI Plus
,
however, the .mem files must always be named with numbers from 1 to 12 and must be found
in the 'organ\memories' folder.
-
When loading from internal memory or USB stick, the combinations are irreparably
overwritten.
