4 of 9 pages
40.
Audio Input-
This jack accepts a line level audio input signal ranged from 100Mv to 1V
pp.
41.
Remote Input-
Black Out and Full On may be controlled by a remote control using a
standard 1/4” stereo jack.
42.
Fog Machine Connector-
Ⅴ
. OPERATION
1.
Being Programming
1.1 Record Enable
1) Press and hold down the Record button.
2) While holding down the Record button, tap the Flash buttons 1,6,6 and 8
in sequence.
3) Release the Record button, the Record LED lights up, now you can begin
programming your chase patterns.
NOTE:
The first time you turn on your unit, the default setting of the Record Code
is Flash buttons 1, 6, 6 and 8.
You may change the Record Code to protect your programs.
1.2 Security for Your Programs
To protect your programs from any editing by others. you may change the
Record Code.
1)
Enter current Record Code(Flash buttons 1, 6, 6 and 8).
2)
Press and hold down the Record and Edit buttons at a time.
3)
While holding the Record and Edit buttons. tap the desired Flash button to
enter a new Record Code.
The record Code consists of 4 Flash buttons (the same button or different
buttons), be sure your new Record Code consists of 4 Flash buttons.
4)
Enter your new Record Code a second time, all channel LEDs and scene
LEDs will flash three times, now the Record Code is changed.
5)
Exit Record mode. Tap the REC Exit button while pressing and holding
down the Record button, release the two buttons at a time, the Record mode
is engaged.
IMPORTANT!!!
Always remember to exit Record mode when you won’t continue your
programming, otherwise you may lose control of our unit.
NOTE:
The second time you enter your new Record Code different from that of the
first time. The LEDS will not flash, which means you’ve failed to change
the Record Code.
When you’ve entered a new Record Code the first, and now you want to
cancel the new Record Code, you may press and hold down the Record and
Exit buttons at a time to exit.
1.3 Program Scenes
1)
Record Enable
2)
Select the 1-48 Single mode by tapping the Mode Select button. This will
give you control of all 48 channels as you program.
Be sure that Master A & B are both set at maximum.(Master A is at its
maximum in the fully up position, while Master B is at its maximum in the
fully down position).
3)
Create a desired scene using Channel Sliders 1-48. At 0% or DMX 255.
these sliders should be at 10 position.
4)
Once the scene is satisfactory. Tap the Record button to program the scene
as step into the memory.
5)
Repeat step 3 and 4 until all desired steps have been programmed into
memory. You may program up to 1000steps into memory.
6)
Select chase bank or scene master to store your program. Lap the Page
button select page (page 1-4) to store your scenes.
7)
Press a Flash button between 25-48 while holding down the Record button.
All LED which flash indicating the scenes have been programmed into
memory.
8)
You can continue programming or exit. To exit Program mode, tap the Exit
