6 of 9 pages
You may read the step from the Segment Display.
4) Tap the Insert button to insert the step you’ve created before all LEDs
will flash. Indicating the step is inserted.
5) Exit Edit mode.
EXAMPLE:
Insert a step with channels 1-12 fully on at a time between step 4
and 5 of program 35.
1) Record enable
2) Push Channel sliders 1-12 to the and record the scene as a step.
3) Tap the Mode Select button to select CHNS◄►SCENE mode.
4) Tap the Page button until Page 2 LED lights.
5) Tap the Flash button 35 while holding down the Edit button. The
corresponding scene LED lights.
6) Tap the Step button to scroll to the step 4.
7) Tap the Insert button to insert the scene you’ve created before.
2.7 Modify a Step or Steps
1) Enter Edit mode.
2) Tap the Step button to scroll to the step you wish to modify.
3) Press and hold the Up button if you want to raise the intensity. If you
want to lower the intensity, press and hold down the Down button.
4) While holding down the Up or Down button, tap the Flash button
corresponding to the DMX channel of the scene you wish to modify until
you reach the desired intensity value read from the Segment Display.
Then you may tap the Flash buttons until you are satisfied with the new
scene.
5) Repeat steps 2. 3 and 4 and until all the steps have been modified..
6) Exit Edit mode.
3. Running
3.1 Running Chase Programs
1) Tap the Mode Select button to select CHNS◄►SCENES mode
indicated by the LED.
2) Tap the Page button to select the correct page the program you wish to
run is located.
3) Push Master Slider B to its maximum position (fully down).
4) Move the desired Channel slider (25-48) to its maximum position to
trigger the program, and the program will fade in depending upon
current fade time.
5) Move the Channel slider to adjust the output of the current program.
3.2 Running a Program To Audio
1) Use built-in microphone or plug the audio source into the RCA Audio
jack.
2) Select your program as described above.
3) Tap the Audio button until its LED lights, indicating Audio mode is
active.
4) Use the Audio level slider to adjust the music sensitivity.
5) To return to normal mode, tap the Audio button a second time causing its
LED goes out, the Audio mode is disengaged.
3.3 Running a Programs With the Speed Slider
1) Be sure the Audio mode is disengaged, that is Audio LED goes out.
2) Select your program as described above.
3) Move the Speed slider to the SHOW MODE position (the button), then
lap the Flash button (25-48) while pressing and holding down the Rec
Speed button, the corresponding program will not run with the Standard
Beat any longer.
4) Now you may move the Speed Slider to select your desired speed.
NOTE:
The step 3 is not necessary if the selected program is not recorded
With Standard Beat.
3.4 Running a Programs With the Standard Beat
1) Be sure the Audio mode is disengaged. Tap the Mode Select button to
select CHNS◄►SCENE mode.
2) Tap the Park button to select Mix Chase mode, the LED lights indicating
this selection.
3) Select our program as described above.