![background image](http://html1.mh-extra.com/html/visage/vis245-stage-desk-48/vis245-stage-desk-48_manual_1030663008.webp)
8 of 9 pages
Close Loop Mode
5) The controller will send and receive Note On Off data via the Flash
buttons
NOTE NUMBER VELOCITY FUNCTION
Decimal Hex
22-69 [16H-45H] Program master Turn on or off program 1-48
22-117 [16H-45H] channel light activate Channel 1-48
118 [76H] FULL-ON
119 [77H] DARK
120 [78H] HOLD
121 [79H] Turn on or off AUDIO
122 [7AH] CHNS◄►SCENES
123 [7BH] DOUBLE PRESET Mode
124 [7CH] SINGLE PRESET Mode
125 [7DH] Step
126 [7EH] BLACK OUT
Ⅵ
. BRIEF OF MAIN FUNCTIONS
1. Reverse the direction of the scene
1) Reverse the direction of all the scenes. Press the ALL REV Button. all the
scenes should change their directions.
2) Reverse the chasing direction of all the programs with speed control;
Press the Chase Rev Button.
3) Reverse the chasing direction of all programs with standard beat: Press
the Beat Rev Button
4) Reverse chasing direction of any program: Press and hold down the Rec
One Button, then press down the Flash Button corresponding to your
desired program and release together.
2. Fade Time
1) The amount of time it will take for dimmer go from zero output to
maximum output, and vice verse.
2) Fade time is adjusted through the Fade Time Slider. Which varies from
instant to 10 minutes.
3. Tap Sync Button
1) The Tap Sync button is used to set and synchronize the chase rate (the
rate at which all scenes will sequence) by tapping the button several
times. The chase rate will synchronize to the time of the last two taps.
The LED above the step Button will flash at the new chase rate. The
chase rate may be set anytime whether or not a program is running
2) Tap Sync will override any previous setting of the speed slier control
until the slider is moved again.
3) Use of Tap Sync in setting a standard beat is the same with speed control
slider.
4. Master Slider
Master Slider control provides proportion level control over all channels and
scenes with the exception of the Flash Buttons For example;
Whenever the Master slider control is at minimum all stage outputs will be at
zero except for any resulting from a Flash Button or FULL ON Button.
If the Maser is at 50%. all outputs will be at only 50% of the setting of current
channel or scenes except for any resulting from a Flash Button or FULL ON
Button.
If the Master is at full all outputs will follow the unit setting.
Master A always controls outputs of channels. Master B controls program or
a scene except in Double Press Mode
5. Single Mode
1) All programs will run in sequential order starting in the order of program
number.
2) The Segment Display will read the running program number.
3) All programs will be controlled by the same Speed Slider.