VIRATA ADSL Ethernet Router Series, Technical Manual

Page: 35 / 84

○ ○ ○ ○ ○
3 — Configuring Your Router
3-19
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
3.7.2 SNMP Trap
i) To add a trap destination:
snmp trap add <community> <IP addr> [<port>]
ii) To delete a trap destination:
snmp trap delete <community> <IP addr> [<port>]
iii) To delete all traps destination:
snmp trap flush
iv) To list trap(s) destination:
snmp trap list
Example:
>snmp trap add community_name 192.168.1.5 21
>snmp trap list
trap add community_name 192.168.1.5 21
>snmp trap delete community_name 192.168.1.5 21
>snmp trap list
No trap destinations set
3.8 Setting up Telnet Access
(By factory default, Telnet Access is enabled . If the feature has been removed from
your router, you may carry out the following steps to enable it.)
Ensure that your router has SNMP write access enabled (see Section 3.7 - Setting
Up SNMP ) before you proceed with the Telnet Access setup.
To enable Telnet to your router:
ip portname add telnet 23/tcp
config save
The Telnet password will be your SNMP write access community name
that you have entered during SNMP setup (
section 3.7.1, step (ii) ).