Manual VIPA System 300S SPEED7
Chapter 4 Deployment CPU 313SC/DPM
HB140E - CPU SC - RE_313-6CF03 - Rev. 07/45
4-7
Initialization Ethernet PG/OP channel
The CPU 313SC/DPM has an integrated Ethernet PG/OP channel. This
channel allows you to program and remote control your CPU with up to 2
connections.
The PG/OP channel also gives you access to the internal web page that
contains information about firmware version, connected I/O devices,
current cycle times etc.
For online access to the CPU via Ethernet PG/OP channel valid IP address
parameters have to be assigned to this by means of the Siemens SIMATIC
manager. This is called "Initialization".
There are the following possibilities for assignment of IP address
parameters (initialization):
•
PLC functions with
Assign Ethernet address
•
Hardware project engineering with CP (Minimal project)
For the hardware configuration the following software is necessary:
•
SIMATIC Manager from Siemens V. 5.1 or higher
•
SIMATIC NET
The initialization takes place after the following proceeding:
•
Determine the current Ethernet (MAC) address of your Ethernet PG/OP
channel. This always may be found as address under the front flap of
the CPU on a sticker on the left side.
Ethernet address
Ethernet PG/OP
Overview
Possibilities for
Initialization
Requirements
Initialization via
PLC functions
Summary of Contents for 313-6CF03
Page 2: ...Lerrzeichen ...