16
www.vintageair.com
905644 REV A 01/10/19, PG 16 OF 33
Wiring Installation
1.
2.
3.
4.
5.
From the passenger compartment, route the heater control valve connector and wiring (red, white and
green) through the 7/8” grommet in the kick panel cover and through the 7/8” grommet in the fresh air cap
(See Photo 1, below).
NOTE: Leave approximately 1” of wiring between the kick panel cover and the
harness connector. This allows enough wiring to reach the harness.
Disconnect the circuit breaker from the main wiring harness (See Photo 2, below).
Route the red, white and blue wires from the main wiring harness through the 7/8” grommet in the kick
panel cover (See Photo 3, below).
NOTE: Leave approximately 5” of wiring between the relay and the
kick panel cover. This allows enough wiring to secure the relay to the mounting position.
Route the heater control valve wiring (red, white and green) through the 7/8” grommet in the fresh air cap
(See Photo 4, below).
Route the main harness wiring (red, white and blue) through the 7/8” grommet in the fresh air cap (See
Photo 5, below).
Photo 1
Photo 2
Photo 4
Photo 5
Photo 3
Circuit Breaker
Approximately 1”
Heater Control Valve
Wiring (Red, White
and Green)
Main Wiring Harness
(Red, White and
Blue)
Fresh Air Cap
622230
Main Wiring Harness
(Red, White and
Blue)
Heater Control
Valve Connector and
Wiring (Red, White
and Green)
Kick Panel Cover
622235
7/8” Grommet
33144-VUI
Kick Panel Cover
622235
7/8” Grommet
33144-VUI
7/8” Grommet
33144-VUI
Fresh Air Cap
622230
7/8” Grommet
33144-VUI
Approximately 5”
Summary of Contents for 564191
Page 33: ......
