10
www.vintageair.com
905644 REV A 01/10/19, PG 10 OF 33
Early-Model Kick Panel Modification
1.
2.
3.
4.
Remove the OEM kick panel grille retaining screw and grille (discard) (See Photo 1, below).
Disconnect and remove the fresh air door cable from the OEM lever housing (discard) (See Photo 2, below).
Remove the fresh air door assembly from the OEM kick panel by lifting up on the door toward the spring and
sliding it out of the hinge housing (See Photo 3, below).
Trim the fresh air door housing flush with the back of the OEM kick panel, and discard the excess material
(See Photo 4, below).
Photo 1
Photo 2
Photo 3
Photo 4
Remove Retaining
Screw and Grille
Disconnect Fresh Air
Door Cable and Remove
Remove Fresh Air
Door Assembly
Trim Fresh Air Door Housing Flush
With Back of OEM Kick Panel
NOTE: If the vehicle is equipped with a late-model kick panel, proceed to Page 11.
Hose Adapter Installation
1.
2.
3.
4.
Cut off 9” of the OEM driver side A/C duct assembly as shown in Figure 1, below.
Install (3) S-clips onto each hose adapter as shown in Figure 1, below.
Install the driver & passenger side hose adapters onto the OEM louvers (See Figure 1, below).
Reinstall the louvers into the dash.
9”
Hose Adapter
49881-VCI
(3) S-clips
(3) S-clips
Cut
Figure 1
Hose Adapter
62615-VCE
Passenger Side
Driver Side
Lift Door
Toward Spring
Summary of Contents for 564191
Page 33: ......
