17
www.vintageair.com
905644 REV A 01/10/19, PG 17 OF 33
Photo 2
Photo 1
Photo 3
Modified OEM Kick Panel
Vacuum Vent Actuator Cover
Kick Panel Installation
1.
2.
3.
4.
Apply a bead of silicone around the mating surface of the kick panel cover (See Figure 1, below).
Install the kick panel cover into place, lining up the mounting holes on the cover with the OEM mounting holes
on the kick panel opening (See Photo 1, below).
Install the kick panel, routing the hoses and wiring through the opening (See Photo 2, below). For an early-
model kickpanel, secure the panel with the trim plate using (3) #8 x 3/4” countersunk washer screws (See
Photo 3, below). For a late-model kick panel, do not install the trim plate. Secure the kick panel using (3) #8 x
3/4” countersunk washer screws.
Secure the main wiring harness relay to the upper kick panel mounting hole using a #8 x 3/4” countersunk
washer screw, mounting it in the hole as shown in Photo 4, below.
NOTE: If your vehicle is equipped with a
kick panel vacuum vent actuator cover, it will need to be modified to fit with the installed hoses (See
Photo 5, below).
Figure 1
Photo 5
Photo 4
Install Kick Panel Cover into
Place, Lining up Mounting Holes
Silicone Mating
Surface
Secure Relay to Upper
Mounting Hole Using #8 x 3/4”
Countersunk Washer Screw
(3) #8 x 3/4” Countersunk
Washer Screws
Install Kick Panel
Kick Panel Trim Plate
640709
Summary of Contents for 564191
Page 33: ......
