7
Gasifying boilers VIGAS
3. DESCRIPTION OF AK 3000 CONTROL
3.1 Safety Instructions
Check protection (cover) metal sheet before plug-in the power wire
Avoid any contact of power wire with hot parts of the boiler (f.e. chimney)
Make sure, no water is allowed under the upper isolation (risk of short circuit)
Do not stress the power wire
Always disconnect the power wire when a new electrical components are connecting (f.e.
indoor thermostat, discharge fan or circulation pump)
Do not remove protection (cover) metal sheet during the boiler operation, especially from
fan
Compare working voltage displayed on the label with your distribution network
Always observe safety regulations
3.2 Connecting to the distributing network
AK 3000 control is integral part of VIGAS boilers.
Control is connected when power wire is plugged in to the distributing network 220/230V. Display
is active when power wire is plugged-in (Pic.4). Servo-flat used in VIGAS
Lambda Control
is set to
base position (Pic.5).
3.3 Working conditions
Operation temperature range of AK 3000 control is +5°C to +45
°
C. Control may not be used in
humid enviroment or direct sunlight.
3.4 Maintainance of AK 3000 control
Keep in clean and dust-free enviroment. Antistatic, or wet wipper is adivsed to wipe-off dust and
impurities from metal cover and control panel.
3.5
Control panel
Part of the electronic control is panel, equipped with buttons, pictograms and display. Futher
informations will be available in the next part of this manual.
Pic.6
Pic.5
1. Graphical display 128 x 64 pixels
2. Button
◄
with functions
3. Button
▲
with functions
4. Button
►
with functions
5. Button (ENTER) with functions
6. LED control
7. Button with functions
Pic.4
Summary of Contents for VIGAS 100
Page 34: ...34 Gasifying boilers VIGAS ...
