Villager Villybot 2.0, Original Instruction Manual, Page: 46 / 272

15
Password
The robotic lawnmower is password protected. To start the lawnmower for the first time,
you have to enter the password (the 2D, 2H, 4H and 6H light flashes). Factory default
password is 1111. You can enter the password by the panel on the top side of the mower.
1. Press CYCLE (for password number “1”). The 2D light is off .
2. Press CYCLE (for password number “1”). The 2H light is off .
3. Press CYCLE (for password number “1”). The 4H light is off .
4. Press CYCLE (for password number “1”). The 6H light is off .
Please note: When no password is entered, the system is in a password protected state,
and the machine cannot be operated through the panel. The machine can be charged. In
this state, the state lamp (1D, 2D, 2H, 4H, 6H) are off and the machine cannot cut grass
automatically.
Start the mower
→
if you have entered the correct password,
5. Press START and SET, or START and CYCLE in order within 3 seconds; if the mower is
at the charging station, password needs to be entered after this step (step 5.)
→
The robotic mower will start mowing when the mowing conditions are allowed.
When the mower starts manually:
The mowing conditions are:
1. The temperature of the mower is within working temperature.
2. There is no water on the rainy detector.
3. Battery is higher than empty battery.
Fig. 15 – Panel on the top side,
status light marked with a red rectangle