Villager Villybot 2.0, Original Instruction Manual, Page: 41 / 272

10
Charging the mower
Your robotic lawnmower´s battery is charged to a
certain degree on delivery, but it´s recommended to
fully charge the battery of the mower before use. To
charge your robotic lawnmower follow these steps:
1. Switch the robotic lawnmower on. The On/Off
switch is located at the bottom side of the robotic
lawnmower.
Please note: Your robotic lawnmower will not charge
when it is not turned on.
Please note: The robotic lawnmower will enter a self-checking state (normally within 5
seconds) after: 1. entering password 2. when power is switched On 3. mowing or charging
be interrupted (indicated by a flashing status light). If the mower is in a self-check state,
you will not hear a sound when pressing a button and the buttons won´t work.
2. Slide the mower into the charging station to charge.
3. Check the indicator on the charging station. The power light turns up, the robotic
lawnmower charges. If the power light does not light up, you should check the mains
plug of the power supply is plugged properly and that the mower is placed in charging
station correctly.
Setting up the perimeter wire
While the mower charges, you can set up the perimeter wire. The robotic lawnmower uses
the wire for orientation. The wire defines the borders of the mowing area. Everything in the
inner area belongs to the mowing area, everything in the outer area doesn´t belong to the
mowing area. The wire also serves to mark obstacles and exclude them from the mowing
area.
1.
Carefully strip off 10-15 mm of the insulation of the wire.
Please note: You should keep a length of 15-20 cm at start and the end of the wire for
easier operating.
Fig. 9 – On / Off switch