Viking MB 443 C, Instruction Manual

Page: 19 / 344

EN
SK
17
TR
HU
SR
HR
CS
LV
LT
RO
EL
BG
ET
AZ
KK
0478 111 9823 E - EN
MB 443, MB 443 T, MB 448 T,
MB 448 TX:
MB 448 TC, MB 448 VC:
7. 1 General
● Place the machine on level and firm
ground when performing all the
operations described.
7.2 Installing the mono handlebar
(MB 448 TC, MB 448 VC)
● Insert the sleeve (I) in the bore
on the handlebar (1).
● Fit the two washers (K) with the convex
side facing inwards onto the sleeve in
the handlebar (1).
● Hold the sleeve (I) and washers (K) and
insert together with the handlebar (1)
into the holder on the handlebar
console (2).
● Insert the screw (J) from the outside
inwards through the bores in the
handlebar (1) and in the handlebar
console (2). Screw on the nut (L) and
tighten the bolt (J).
Tightening torque:
1 8 - 22 Nm
Risk of injury!
Keep your hands and feet
away from the blades.
Cutting tool runs on for sev-
eral seconds after switching
off (engine/blade brake).
MB 443, MB 443 T,
MB 448 T, MB 448 TX:
Starting the engine
MB 443, MB 443 T,
MB 448 T, MB 448 TX:
Stopping the engine
MB 443 T, MB 448 T,
MB 448 TX:
Switching on self-propulsion
MB 448 TC, MB 448 VC:
Starting the engine
MB 448 TC, MB 448 VC:
Stopping the engine
MB 448 TC, MB 448 VC:
Switching on self-propulsion
MB 448 VC:
Set the driving speed.
(
Ö 11.3)
6. Standard equipment
Item Designation Qty.
A Basic unit 1
B Upper part of grass catcher
box 1
C Lower part of grass catcher
box 1
D Pin 2
– Instruction manual 1
– Instruction manual,
Engine 1
Item Designation Qty.
E Quick-clamping devices 2
F Bolt 2
G Cable guide 2
H Protective sleeves 2
2
Item Designation Qty.
I Sleeve 1
J Bolt 1
K Washer 2
L Nut 1
7. Preparing the machine for
operation
Risk of injury!
Observe the safety instructions in
the section "For your safety" (
Ö 4.).
3