VIEWEG
EN
Problem
Potential Cause
Lösung
Plunger discs cannot
enter the cartridge
Cartridge not fully
inserted in cartridge
bed
Check that there is
no foreign matter in
the cartridge bed.
Push the cartridge
fully down into the
cartridge bed. Mind
your fingers.
The cartridge cannot
be removed from the
dispenser.
The plunger discs are
still in position inside
the cartridge.
Press the red button
to fully retract the
plunger discs to the
back end-stop.
Sulzer Mixpac AG
22905825v3
5.
Troubleshooting:
6.
Maintenance and repair:
Notices
All maintenance and repairs must only be carried out by
sites authorized by the manufacturer and exclusively by
qualified and suitably trained personnel.
Always disconnect the compressed air supply from the
dispenser during maintenance and repairs.
Never open the pneumatic drive unit. If the pneumatic
drive unit is or appears to be in need of maintenance or
repair, contact a Sulzer Mixpac authorized Service Center.
Keep the dispenser clean at any time. Failure to do so
may result in malfunction of dispenser or bodily
injury.
Do not use aggressive cleaning products to clean the
surface of the device.
Problem
Potential Cause
Remedy
Plunger discs cannot
enter the cartridge
Cartridge not fully
inserted in cartridge
bed
Check that there is
no foreign matter in
the cartridge bed.
Push the cartridge
fully down into the
cartridge bed.
Mind
your fingers.
The cartridge cannot
be removed from the
dispenser
.
The plunger discs are
still in position inside
the cartridge
.
Press the red button
to fully retract the
plunger discs to the
back end-stop.
10
2009-03 (V 2.0)
Dispenser DP
5 Troubleshooting
6 Maintenance and repair
6.1 Notices
20
21
Operating Manual 990268-X