About This Guide
4
ViewCast
FCC notice
WARNING! You must connect this device and peripherals using shielded cables to comply with FCC
radio emission limits.
WARNING! Modifications to this device not approved by ViewCast Corporation could void the FCC-
granted authority for you to operate the device.
WARNING! The Niagara 4100 complies with the limits for a Class A digital device pursuant to Part 15
of the FCC Rules. These limits provide reasonable protection against harmful interference when you
operate the equipment in a commercial environment. This equipment generates, uses, and may
radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area will likely cause harmful interference. In this case you must correct the interference
at your own expense.
To CATV Installer: Pay special attention to Section 820-40 of the NEC that provides guidelines for
proper grounding. It particularly specifies that you must connect the cable ground to the grounding
system of the building as close to the point of cable entry as practical.
WARNING! Equipment installation must comply with local and national electrical codes.
Summary of Contents for Niagara 4100
