Viessmann BWT 241.A Series, Installation And Service Instructions Manual

Page: 109 / 124

109
Parameter Code Delivered condi-
tion Commis-
sioning
Internal hydraulics
Heat pump for drying a building 7300 0
Time program for screed drying 7303 0
Set flow temperature, external demand 730C
500 (
≙
50 °C)
Operating mode primary pump 7320 Do not adjust
Operating mode secondary pump 7340 Do not adjust
Heating water buffer cylinder
Enable buffer cylinder / low loss header 7200 0
Temp. in operating status fixed value for
buffer cyl 7202
500 (
≙
50 °C)
Hysteresis temperature heating buffer
cylinder 7203 50 (
≙
5 K)
Max. temperature buffer cylinder 7204 600 (
≙
60 °C)
Temp. limit op. status fixed value for buf-
fer cylinder 7208 100 (
≙
10 °C)
Heating circuit 1
Standard room temperature 2000 200 (
≙
20 °C)
Reduced room temperature 2001
160 (
≙
16 °C)
Remote control 2003 0
Heating curve level 2006
0 (
≙
0 K)
Heating curve slope 2007
6 (
≙
0.6)
Influence room temperature hook-up 200A 10
Room temperature hook-up 200B 3
Max. flow temperature heating circuit 200E
400 (
≙
40 °C)
Room temperature in party mode 2022
200 (
≙
20 °C)
Heating circuit 2
Standard room temperature 3000
200 (
≙
20 °C)
Reduced room temperature 3001 200 (
≙
20 °C)
Remote control 3003 0
Heating curve level 3006
0 (
≙
0 K)
Heating curve slope 3007
6 (
≙
0.6)
Influence room temperature hook-up 300A 10
Room temperature hook-up 300B 3
Max. flow temperature heating circuit 300E 400 (
≙
40 °C)
Room temperature in party mode 3022
160 (
≙
16 °C)
Commissioning/service reports
Control parameters report
(cont.)
5601 598 GB
Service