If static IP is selected, then the screen prompt will be changed as follows:
Key in the static IP address, Gateway and Sub-Net address using the numeric keys on remote controller.
This network setting is for client software operation over the network.
1.4-2Dynamic internet protocol
If dynamic internet protocol is selected, the screen prompt will be changed as follows:
Then the unit will obtain an IP address from assigned IP Switch. It will usually take 1 to 2 minutes after
entering this menu item, for the unit to obtain the dynamic IP address. Once the dynamic IP address is
obtained successfully, then this menu item will be quitted automatically.
Caution: During the assignment of Dynamic IP address, lack of response from this unit on “Enter”
button being pressed is normal and do not indicate a malfunction. It might take longer time to boot with
Dynamic IP.
1.4-3Network Password
Under this item, the screen prompt is as follows:
Under this item, operator is allowed to change the network password. The network password is a
combination of 4 digits from 0 to 9. The default network password is “1111”. Operator should use
numeric key on front panel or remote controller to input the new password.
IP Address
: 192.168.001.201
GATEWAY
: 192.168.001.001
NETWORK
: 255.255.255.000
Static IP
Dynamic IP
〔
Enter new Password
〕
：
__ __ __ __
〔
Re-enter Password
〕
：
__ __ __ __
27
