Press Up or down to select the camera number, and left or right to select the motion detection recording
property.
Motion Detection: The “Standard”, “Sensitive” or “Off” fields, is to indicate whether the motion
detection for that camera is activated or not, if activated which level of sensitivity is set.
Sensitivity
：
Two levels, “Standard” or “Sensitive”. Operator should determined the setting basing
on the camera picture condition, including lighting condition, desired sensitivity and type of
environment under surveillance (indoor, outdoor etc..).
Time Setting: The unit will record video clip starting from 30 seconds before the motion detected,
and to 30 seconds after the motion detected. Pre-alarm period is depend on compression rate.
Alarm Output
：
Select whether alarm output will be triggered on motion being detected. Please
refer to the alarm management setting section for further detail.
1.2-2 Sensor Detection
Sensor detection triggered recording is the recording mode, under which the recording will be triggered
by one of the four Sensor inputs of the unit being in alarm condition. Under this item, the screen prompt
is as follows:
Press Up or down to select the camera number, and left or right to select the alarm input recording
property.
Alarm Input Activation: This is to select whether an individual sensor input is activated or off.
The sensor input will be ignored if the input is selected to be off.
Time Setting:
：
The unit will record video clip starting from 30 seconds before the sensor detected,
and to 30 seconds after the sensor detected. Pre-alarm period is depend on compression rate.
Alarm Output
：
Select whether alarm output will be triggered on sensor being detected. Please
refer to the alarm management setting section for further detail.
〔
Motion Detection
〕
# 1 STD SEN
〔
OFF
〕
# 2 STD SEN
〔
OFF
〕
# 3 STD SEN
〔
OFF
〕
# 4 STD SEN
〔
OFF
〕
〔
Sensor Detection
〕
# 1 ON
〔
OFF
〕
# 2 ON
〔
OFF
〕
# 3 ON
〔
OFF
〕
# 4 ON
〔
OFF
〕
19
